2.7.2 I nternal connectors

1. Fl oppy di sk dri ve connector (34-1 pi n FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

The Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5.

FLOPPY

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

A8N-SLI PREMIUM

PIN 1

A8N-SLI PREMIUM Floppy disk drive connector2. I DE connectors (40-1 pi n PRI _I DE, SEC_I DE)

These connectors are for Ultra DMA 133/100/66 signal cables. The Ultra DMA 133/100/66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 133/100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 133/100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.

•The Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for UltraDMA133/100/66 IDE devices.

A8N-SLI PREMIUM

SEC IDEPRI IDE

 

PIN 1

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

A8N-SLI PREMIUM IDE connectors

ASUS A8N-SLI Premium

2-21