10 . Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

A8V-E

DELUXE

+5VSB MB

Chassis Signal GND

CHASSIS

(Default)

A8V-E DELUXE Chassis alarm lead

11 . IEEE 1394 connector (10-1 pin IE1394_2)

These connectors are for IEEE 1394a ports. Connect the IEEE 1394 module cable to this connector, then install the module to a slot opening at the back of the system chassis.

A8V-E

DELUXE

IE1394_2

A8V-E DELUXE IEEE 1394 connector

+12V

TPB2+

GND

TPA2+

GND +12V

TPB2-

GND

TPA2-

1

Never connect a USB cable to the IEEE 1394a connectors. Doing so will damage the motherboard!

2 - 30

Chapter 2: Hardware information