7.Make sure that the drive and bay holes align as shown. When in place, the drive protrudes about an inch from the front panel.

8.Pull down the bar lock and insert the lock pegs to the drive/bay holes, then push the drive lock to the right to secure the drive.

9.On the front panel assembly, detach the plastic bay cover opposite the 5.25-inch drive that you installed by pressing the two hooked tabs on each side of the bay cover.

10.Re-install the front panel assembly when done. Refer to section “2.5.2 Re-installing the front panel assembly” for instructions.

2-16

Chapter 2: Hardware setup