3.HARDWARE SETUP

25)ATX Power Supply Connector (20-pin block ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup- ply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the +5-volt standby lead (+5VSB). You may experience difficulty in powering ON your system if your power supply cannot support the load. For Wake- On-LAN support, your ATX power supply must supply at least 720mA +5VSB.

 

+3.3

Volts

+3.3 Volts

 

-12.0 Volts

+3.3 Volts

 

Ground

Ground

 

Power Supply On

+5.0 Volts

 

Ground

Ground

 

Ground

+5.0 Volts

 

Ground

Ground

CUW(E)-FX

-5.0

Volts

Power Good

 

+5.0

Volts

+5V Standby

 

+5.0

Volts

+12.0 Volts

CUW(E)-FX ATX Power Connector

26)Power Supply Thermal Sensor Connector (2-pin block JTPWR)

If you have a power supply with thermal monitoring, connect its thermal sensor cable to this connector.

H/W SETUP

Connectors

3.

 

 

 

CUW(E)-FX

JTPWR

Power Supply Thermal Sensor

CUW(E)-FX Thermal Sensor Connector

ASUS CUW(E)-FX User’s Manual

39