4.Fan control setting (3-pin CPUFAN_SET1, CHAFAN_SET1)

These jumpers allow you to switch for fan pin selection. The CPUFAN_SET1 jumper is for the CPU fans control and CHAFAN_SET1 is for the other fans control including front fans, rear fans and FB-DIMM fans. Set to pins 1-2 for 4-pin fans or pins 2-3 for 3-pin fans.

 

FAN_SET1

(CPU Fan)

 

FAN_SET2

(Other Fans)

1

2

2

3

Balanced

DC FAN

(Default)

 

 

DSEB-DG Series FAN setting

• If you use a 4-pin fan but set the jumper to pin 2-3, the fan you installed may not work.

•If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan controll will not work and the fan you installed will always run at full speed.

5.Intel® 6321ESB SATA port S/W RAID setting (3-pin RAID_SEL1) (DSEB-DG model only)

This jumper allows you to select the Serial ATA RAID configuration utility to use when you create disk arrays. Both utilities are supported by the

Intel® 6321ESB. Place the jumper caps on pins 1-2 if you want to use the LSI

MegaRAID Serial ATA RAID utility (default); otherwise, place the jumper caps on pins 2-3 to use the Intel® Matrix Storage Manager (IMSM).

 

RAID_SEL1

 

2

3

 

2

 

1

 

DSEB-DG Series RAID setting

LSI

Intel

(Default)

 

2-30

Chapter 2: Hardware information