Asus E3746 STRIKER II EXTREME, STRIKER II EXTREME, STRIKER II NSE USB2.0 connectors, STRIKER II NSE Floppy disk drive connector

3.Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.

FLOPPY

STRIKER II EXTREME

PIN1

NOTE:Orient the red markings

on the floppy ribbon cable to PIN 1.

STRIKER II EXTREME/

STRIKER II NSE Floppy disk drive connector4.USB connectors (10-1 pin USB 78; USB 910)

These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with USB 2.0 specification that supports up to 480 Mbps connection speed.

		USB78	USB+5V USB P8- USB P8+	GND NC	USB910	USB+5V USB P10- USB P10+	GND NC
	STRIKER II EXTREME
		PIN 1			PIN 1
			USB+5V USB P7- USB P7+	GND		USB+5V USB P9- USB P9+	GND
STRIKER II EXTREME/

STRIKER II NSE USB2.0 connectors

Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!

	You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and
	then install the Q-Connector (USB) to the USB connector onboard.
2-34	Chapter 2: Hardware information