For watercooling system with 1/2” or 10mm ID tubes

1.Insert a fitting (1/2” to 3/8” ID or 10mm to 3/8” ID) into the tube.

Your watercooling system may come with tube clamps. Use a clamp to fasten the fitting and the tube together.

2.Connect a supplied 3/8” ID tube to the fitting.

3.Loosen the screw of a 1/2” ID tube clamp and hitch it to the bottom end of the 3/8” ID tube. Tighten the clamp screw with a screwdriver.

4.Hitch another clamp to the top end of the 3/8” ID tube.

1

2

3

4

 

 

 

 

5.Connect the assembled tube to the waterblock and tighten the screw of the clamp using a screwdriver.

6.Repeat Step 1 to 5 for another tube. Make sure that both tubes are well connected to prevent leak, and then fill the coolant into the reservoir.

5

 

6

 

 

 

ROG Striker II Extreme / Striker II NSE

2-45