2.8.4Installing Fusion Block System accessory

Install your watercooling system to the motherboard using the bundled accessories to obtain the best thermal solution.

Package contents

3/8” ID tubes x 2 1/2” to 3/8” ID fittings x 2 10mm to 3/8” ID fittings x 2

3/4” ID tube clamps x 2

1/2” ID tube clamps x 6

For watercooling system with 3/8” ID tubes

1.Loosen the screw of a 1/2” ID tube clamp and fit the tube into the clamp.

2.Connect the tube to the waterblock and tighten the screw of the clamp using a screwdriver.

3.Repeat Step 1 and 2 for another tube. Make sure that both tubes are well connected to prevent leak, and then fill the coolant into the reservoir.

12

2-44

Chapter 2: Hardware information