If you want to create a RAID 0, 1, 0+1, 5 or JBOD configuration from the Serial ATA hard disk drives, set this item to [RAID]�.

If you want to use the Serial ATA hard disk drives as Parallel ATA physical storage devices, keep the default setting [IDE]�.

If you want the Serial ATA hard disk drives to use the Advanced Host Controller Interface (AHCI), set this item to [AHCI]�.

Use SATA 1–4 connectors for IDE mode. SATA 5–6 connectors support AHCI mode and RAID mode only. Make sure to install the AHCI driver or RAID driver in the bundled support DVD before connecting devices to SATA 5–6 connectors. Otherwise, the devices will not work.

4.5.7LCD Poster and Onboard LED Control

Phoenix-AwardBIOS CMOS Setup Utility

Advanced

LCD Poster and Onboard LED Control

Select Menu

 

 

 

ROG Logo

[Enabled]

Item Specific Help

Voltiminder LED

[ON]

Set ROG Logo Enabled/

Disabled

SB LED Selection

[SB Voltage]

LCD Poster Off

[Enabled]

 

LCD Poster Backlight

[Disabled]

 

LCD Poster Mode

[Current Time]

 

x LCD Poster String

F1:Help

↑↓ : Select Item

-/+: Change Value

F5: Setup

Defaults

ESC: Exit

→←: Select Menu

Enter: Select SubMenu

F10: Save

and Exit

ROG Logo [Enabled]

If this item is set to [Enabled]�, the box labeled as Republic of Gamers on the heatpipe assembly lights up when the system is on.

Configuration options: [Enabled] [Disabled]

Voltiminder LED [ON]

Allows you to turn on/off the onboard Voltiminder LED.

Configuration options: [ON] [OFF]

LCD Poster Off [Enabled]

Allows you to enable or disable the LCD Poster.

Configuration options: [Disabled] [Enabled]

4-32

Chapter 4: BIOS setup