8.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

CROSSHAIR II FORMULA

+5VSB MB

Chassis Signal GND

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CHASSIS

CROSSHAIR II FORMULA Chassis intrusion connector9.Digital audio connector (4-1 pin SPDIF_OUT for ASUS HDMI VGA card)

This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port(s). If you are using an ASUS HDMI-equipped graphics card, connect the HDMI card to this connector with a S/PDIF Out cable.

SPDIF_OUT

GND

SPDIFOUT

+5V

CROSSHAIR II FORMULA

CROSSHAIR II FORMULA Digital audio connector

The ASUS HDMI-equipped graphics card and the S/PDIF Out cable are purchased separately.

2-34

Chapter 2: Hardware information