3.Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.

FLOPPY

CROSSHAIR II FORMULA

PIN1

NOTE:Orient the red markings

on the floppy ribbon cable to PIN 1.

CROSSHAIR II FORMULA Floppy disk drive connector4.USB connectors (10-1 pin USB 78; USB 910; USB1112)

These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with USB 2.0 specification that supports up to 480 Mbps connection speed.

CROSSHAIR II FORMULA

PIN 1

CROSSHAIR II FORMULA USB 2.0

 

USB1112

 

 

USB910

 

 

USB78

USB+5V USB_P12- USB_P12+

GND NC

 

USB+5V USB_P10- USB_P10+

GND NC

 

USB+5V USB_P8- USB_P8+

GND NC

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PIN 1

 

 

 

 

 

 

 

PIN 1

 

 

 

 

 

 

 

USB+5V USB_P11- USB_P11+

GND

 

USB+5V USB_P9- USB_P9+

GND

 

USB+5V USB_P7- USB_P7+

GND

connectors

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!

You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and then install the Q-Connector (USB) to the USB connector onboard.

ASUS Crosshair II Formula

2-31