5.1.2Installing hard disk drives

The motherboard supports both Serial ATA and SCSI (NCLV-DS2 model only) hard disk drives for RAID configuration. For optimal performance, install identical drives of the same model and capacity when creating a disk array.

To install the SATA hard disks for RAID configuration:

1.Install the SATA hard disks into the drive bays following the instructions in the system user guide.

2.Connect a SATA signal cable to the signal connector at the back of each drive and to the SATA connector on the motherboard.

3.Connect a SATA power cable to the power connector on each drive.

To install the SCSI hard disks for RAID configuration:

1.Install the SCSI hard disks into the drive bays following the instructions in the system user guide.

2.Connect the SCSI interface cable connectors at the back of the SCSI drives.

3.Connect the other end of the SCSI interface cable to the SCSI connector on the motherboard.

5.1.3Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA hard disk drives attached to the SATA connectors supported by the Intel® 6300ESB Southbridge chip. To do this:

1.Enter the BIOS Setup during POST.

2.Go to the Main Menu, select IDE Configuration, then press <Enter>.

3.Set the Onboard IDE Operate item to [Enhanced Mode], then press <Enter>.

4.Set the Enhanced Mode Support On item to [S-ATA], then set the Configure S-ATA as RAID item to [Yes].

5.Save your changes, then exit the BIOS Setup.

Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.

5 - 2

Chapter 5: RAID configuration