INSTALLATION .III CPU

III.INSTALLATION

5.Insert the SEC Cartridge: Push the SEC cartridge’s two locks inward until you hear a click (the preceding picture shows the locks in the outward position and inward in the picture below). With the heatsink facing the motherboard’s chipset, press the cartridge gently but firmly until it is fully inserted. (NOTE: The procedures shown here are for installing the AAVID heatsink with fan.)

Push lock inward

IMPORTANT: If you are installing only one processor, you must install it in the SEC slot for CPU 1 (slot closest to the external connectors). Then terminate the empty slot with the ASUS C-P2T PC100 CPU termination card to maintain signal strength.

IMPORTANT: Use only the ASUS C-P2T PC100 CPU termination card (Rev. 1.02 or later) to terminate the empty slot.

6.Secure the SEC Cartridge: Secure the SEC cartridge in place by pushing the SEC cartridge locks outward so that the lock shows through the retention mechanism’s lock holes.

lock holes

22

ASUS P2B-D/P2B-DS User’s Manual