III.INSTALLATION

12.Wake-On-LAN (3-pin WOL)

This connector connects to LAN cards with a Wake-On-LAN output, such as the AUS PCI-L101 (see section VII. ASUS LAN Card). The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that the Wake-On-LANPower Up Con- trol is set to Enabled (see “Power Management Setup” under IV. BIOS SOFT- WARE) and that your system has an ATX power supply with at least 720mA +5V standby power.

PME

Ground

+5 Volt Standby

IMPORTANT: Requires an ATX power supply with at least 720mA +5-volt standby power

P2B-D/DS Wake on LAN Connector

13.Chassis Intrusion Sensor Lead (CHASSIS) (optional/reserved)

This lead is for a chassis intrusion monitor or sensor. The sensor is triggered when a high level signal is sent to the CHASSIS lead. This occurs when the side panel is opened or drive bay doors are opened. This motherboard has a light detection on board, which detects extreme levels of light entering the chassis such as when the chassis is opened. This function is available only with the optional hardware monitor installed.

INSTALLATION

Connectors

III.

 

 

 

+5VSB

Chassis Signal

Ground

P2B-D/DS Chassis Open Alarm Lead

ASUS P2B-D/P2B-DS User’s Manual

31