Asus P3B-1394 ASUS P3B-1394User’s Manual, 23)Reset Switch Lead (2-pinRESET), 21)IDE Activity LED Lead (2-pinIDELED), 22)System Power LED Lead (3-1pin PLED)

3.HARDWARE SETUP

21)IDE Activity LED Lead (2-pin IDELED)

This 2-pin connector supplies power to the cabinet’s IDE activity LED. Read and write activity by devices connected to the Primary or Secondary IDE con- nectors will cause the LED to light up.

22)System Power LED Lead (3-1 pin PLED)

This 3-1 pin connector connects to the system power LED, which lights when the system is powered ON and turns OFF when it is in sleep or soft-off mode.

23)Reset Switch Lead (2-pin RESET)

This 2-pin connector connects to the case-mounted reset switch for rebooting your computer without having to turn off your power switch. This is a preferred method of rebooting to prolong the life of the system’s power supply.

24)ATX Power Supply Connector (20-pin ATXPWR)

This connector connects to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly but gently making sure that the pins are aligned.

	+12.0	Volts	+5.0 Volts
	+5V Standby		+5.0 Volts
	Power Good		-5.0 Volts
	Ground		Ground
	+5.0	Volts	Ground
	Ground		Ground
	+5.0	Volts	Power Supply On
	Ground		Ground
	+3.3	Volts	-12.0 Volts
	+3.3 Volts		+3.3 Volts
P3B-1394

P3B-1394 ATX Power Connector

IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. For Wake-On- LAN and suspend-to-RAM support, your ATX power supply must supply at least 720mA +5VSB.

.3 SETUPH/W

Connectors

ASUS P3B-1394 User’s Manual 37