Create Stripe Raidset options

Source

Displays the first selected disk.

Target

All available disks except the first selected disk.

Create Only

This operation destroys all data on the selected

 

disk and creates a clean stripe array without any

 

data.

Split data (Boot from IDE)

This operation will split the data from the source disk into all the selected disks. In this mode, the boot disk may not be booted from the SiS 180 chip.

Split data (Boot from 180)

This operation is similar to “Split data into RAID 0 operation, but the boot disk may boot from the SiS 180 chip.

OK

Starts the array configuration.

Cancel

Aborts the array configuration.

<Disk Copy Remaining Sector> Displays the remaining splitting data

6.Click OK after setting the values.

7.The following warning message appears when the operation is Split data into RAID 0. Click Yes to continue or No to cancel.

8.A restart warning message appears after configuration is completed. Click OK.

Refer to the SiS 180 Serial ATA User’s Manual in the support CD for details on the SiSRAID utility.

5-24

Chapter 5: Software support