2.Floppy disk drive connector
This connector is for the provided Floppy Disk Drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5.
FLOPPY
NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.
PIN 1
P5GV-MX Floppy Disk Drive Connector
3.CPU and chassis fan connectors
The fan connectors support cooling fans of 350mA~2000mA (24W max.) or a total of 1A~3.48A (41.36W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! DO NOT place jumper caps on the fan connectors.
CHA_FAN
GND +12V Rotation
1 
CPU_FAN
CPU FAN PWM
CPU FAN IN
CPU FAN PWR
GND
| 1 |
|
Chapter 1: Product introduction |
