4.4.4Marvell® RAID configurations
The Marvell® 6121 Serial ATA controller allows you to configure RAID 0 and RAID 1 sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set(s). To do this:
1.Install two Serial ATA hard disk drives to the eSATA connectors on the rear panel.
2.Boot up your computer, and press <Del> during POST to enter the BIOS setup.
3.In the Advanced Menu, go to Onboard Devices Configuration, and set Marvell IDE/eSATA to [RAID Mode].
BIOS SETUP UTILITY
| Advanced |
|
| ||
| Onboard Devices Configuration | Enable or Disable | |||
|
|
|
| High Definition Audio | |
| High Definition Audio | [Enabled] | |||
| Controller | ||||
| Front Panel Type | [HD Audio] |
|
| |
| SPDIF OUT Mode Setting | [SPDIF] |
|
| |
| Realtek Gigabit LAN | [Enabled] |
|
| |
| LAN Boot ROM | [Disabled] |
|
| |
| Realtek Gigabit LAN2 | [Enabled] |
|
| |
| Agere Firewire 1394 | [Enabled] |
|
|
|
| Marvell IDE/eSATA | [RAID Mode] |
|
|
|
| IDE/eSATA Boot ROM | [Enabled] |
|
|
|
| Serial Port1 Address | [3F8/IRQ4] |
| Select Screen | |
|
|
|
|
| |
|
|
|
|
| Select Item |
|
|
|
| +- | Change Option |
|
|
|
| F1 | General Help |
|
|
|
| F10 | Save and Exit |
|
|
|
| ESC | Exit |
v02.61 (C)Copyright
3.Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and may not exactly match the items on your screen.
ASUS P5Q WS |