DMA Mode [Auto]
Selects the DMA mode.
Configuration options: [Auto] [SWDMA0] [SWDMA1] [SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables
Configuration options: [Disabled] [Enabled]
3.3.6Storage Configuration
The items in this menu allow you to set or change the configurations for the SATA devices installed in the system. Select an item then press <Enter> if you want to configure the item.
BIOS SETUP UTILITY
|
|
|
|
Main |
|
| |
Storage Configuration |
|
| |
| Options | ||
SATA#1 Configuraton | [Enhanced] | Disabled | |
Configure SATA#1 as | [IDE] | ||
|
|
| Compatible |
Hard Disk Write Protect | [Disabled] | Enhanced | |
IDE Detect Time Out (Sec) | [35] |
| |
SATA#1 Configuration [Enhanced]
Configuration options: [Disabled] [Compatible] [Enhanced]
Configure SATA#1 as [IDE]
Sets the configuration for the Serial ATA connectors supported by the Southbridge chip. Configuration options: [IDE] [RAID] [AHCI]
• If you want to use the Serial ATA hard disk drives as Parallel ATA physical storage devices, keep the default setting [IDE].
•If you want the Serial ATA hard disk drives to use the Advanced Host Controller Interface (AHCI), set this item to [AHCI]. The AHCI allows the onboard storage driver to enable advanced Serial ATA features that increases storage performance on random workloads by allowing the drive to internally optimize the order of commands.
•If you want to create a RAID 0, RAID 1, RAID 5, RAID 10, or the Intel®
Matrix Storage Technology configuration from the Serial ATA hard disk drives, set this item to [RAID].
Chapter 3: BIOS setup |