| LSI Corp Config Utility | v7.07.00.00 (2010.04.30) |
|
|
| |||||
|
|
|
| |||||||
| Create New Volume | SAS2008 |
|
|
|
|
|
| ||
| Volume Type: |
|
|
| RAID 1E |
|
|
| ||
| Volume Size(GB): |
|
| 222 |
|
|
|
| ||
| Slot | Device Identifier |
| RAID | Drive | Pred | Size |
| ||
| Num |
|
|
|
| Disk | Status | Fail | (GB) |
|
| 0 | ATA | ST3160812AS | E | [Yes] | No | 149 |
| ||
| 1 | ATA | ST3160812AS | E | [Yes] | No | 149 |
| ||
| 2 | ATA | ST3160812AS | E | [Yes] | No | 149 |
| ||
| 3 | ATA | ST3160812AS | E | [No] | No | 149 |
| ||
|
|
|
|
|
|
|
|
|
|
|
| Esc = Exit Menu | F1/Shift+1 = Help | C = Create volume |
|
|
| ||||
| SPACE/+/- = Select disk for volume |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
By default, the RAID Disk field shows No before volume creation. This field is grayed out under the following conditions:
•The disk does not meet the minimum requirements for use in a RAID volume.
•The disk is not large enough to mirror existing data on the primary drive.
•The disk is already part of another volume.
4.Repeat step 3 to add the other disks to the volume.
5.When done, press <C> to create the volume, then select Save changes then exit this menu.
Create and save new volume?
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
6.The utility creates the volume.
LSI Corp Config Utility | v7.07.00.00 (2010.04.30) |
|
|
Processing...may take up to 1 minute
Creating RAID Volume...
Chapter 5: RAID configuration |