2.1Chassis cover
2.1.1Removing the front cover
1.Use a Phillips screwdriver to remove the screw on each front end of the top cover.
2.Loosen the two thunbscrews on the rear panel to release the top cover from the chassis.
3.Firmly hold the cover and slide it toward the rear panel for about half an inch until it is disengaged from the chassis.
4.Released a drive tray by pushing the spring lock to the right. Then , firmly hold the tray level and pull all the drive trays out of the bay.
2 - 2 | Chapter 2: Hardware setup |