This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.
FLOPPY1
| PIN 1 |
| NOTE: Orient the red markings on |
the floppy ribbon cable to PIN 1. | |
|
This connector is for an Ultra ATA 100/66/33 signal cable. By default, this connector supports the optical disk drive. You must configure the optical drive as master/slave device by setting its jumper accordingly. Refer to the optical disk drive documentation for the jumper settings.
Pin 20 on the IDE connectors are removed to match the covered hole on the Ultra ATA cable connector. This prevents incorrect insertion when you connect the IDE cable.
PRI_IDE1
PIN 1
NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.
ASUS | 4 - 9 |