SETUP H/W .3
Jumper
3.HARDWARE SETUP
3.3Hardware Setup Procedure
Complete the following steps before using your computer:
1.Check motherboard settings
2.Install memory modules
3.Install the Central Processing Unit (CPU)
4.Install a CPU terminator, if you installed only one CPU.
5.Install Expansion Cards
6.Connect ribbon cables, panel wires, and power supply cables
7.Configure the BIOS parameter settings
Take note of the following precautions before you install motherboard components or change any motherboard settings.
1.Unplug the power cord from the wall socket before touching any internal component.
2.Use a grounded wrist strap or touch a safely grounded object, such as the power supply case, before handling components to avoid damaging them due to static electricity.
3.Hold components by the edges and do not touch the ICs on them.
4.Whenever you uninstall any component, place the components on a grounded antistatic pad or in the bag that came with the component.
5.Before you install or remove any component, ensure that the ATX power supply is switched off or the power cord is detached from the power supply. Failure to do so may cause severe damage to the motherboard, peripherals, and/or components.
3.4Jumper Settings
There is only one jumper on the motherboard. This jumper allows you to set the speed for the PCI slots.
P1_66EN
1 | 2 | 2 | 3 |
Normal | Force 33Mhz | ||
(Default) |
|
| |
16 | ASUS |