3.HARDWARE SETUP

2)Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connecting the single end to the board, connect the two plugs on the other end to the floppy drives. (Pin 5 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 5 plugged).

TRL-DLS

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

PIN 1

TRL-DLS Floppy Disk Drive Connector

3)Wake-On-LAN Connector (3-pin WOL_CON)

This connector supports a LAN card with a Wake-On-LAN output. The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that the BIOS item Onboard LAN Power Up is enabled (see 4.5.1 Power Up Control) and that your system has an ATX power supply with at least 720mA +5V standby power.

TRL-DLS

IMPORTANT: Requires an ATX power supply with at least 720mA +5 volt standby power

WOL_CON

Ground

PME +5 Volt Standby

TRL-DLS Wake-On-LAN Connector

3. H/W SETUP

Connectors

ASUS TRL-DLS User’s Manual

25