2.55.25-inch drives

Unplug the power cable before installing or removing any system components. Failure to do so may cause damage to the motherboard and other system components!

This system comes with three 5.25-inch drive bays located on the upper front part of the chassis. An optional optical drive may occupy the uppermost bay (labeled 1). The lower bays (labeled 2 and 3) are available for additional 5.25-inch optical, zip, or floppy disk drives.

You must remove the front panel assembly before installing a 5.25-inch drive.

Installing a 5.25-inch drive

1.Unscrew and remove the metal cover of the bay where you want to install the 5.25-inch drive, and take off the plastic cover on the front bezel at the same position.

2.Insert the drive into the bay and slide the bay lock to the right until it clicks in place.

1

2

3

2

3.

Connect the SATA cable to the

 

 

 

 

 

SATA connector on the back of the

 

 

 

drive.

4

3

4.

Connect a power plug from

 

 

the power supply to the power

 

 

 

connector on the back of the drive.

 

 

 

 

 

 

2-12

Chapter 2: Hardware setup