2.Firmly hold the tray lever and pull the drive tray out of the bay.
3.Take note of the drive tray holes. Each side has three holes to fit different types of hard disk drives. Use two screws on each side to secure the hard disk drive.
4.Place a SATAII/SAS hard disk drive on the tray, and then secure it with four screws.
5.Carefully insert the drive tray and push it all the way to the end of the bay until just a small fraction of the tray edge protrudes.
When installed, the SATAII/SAS connector on the drive connects to the SATAII/ SAS interface on the backplane.
Chapter 2: Hardware setup |