2.1Preparation
Basic components to install
You need to install the following components to the VENTO 3600 chassis kit.
1.Motherboard
2.Power supply unit (PSU)
3.Hard disk drive
4.
5.Floppy disk drive(s)
6.Expansion card(s)
Tool
You need a Phillips (cross) screw driver to install some system components.
2.2Removing the side panel
To remove the side panel: |
| |
1. Remove the cable |
| |
1 | ||
management kit by pushing | ||
| ||
downward to release the top |
| |
tabs. |
|
2.Pull up the cable management kit to release the bottom tabs.
2
The cable management kit is not a handle. Do not move or lift the chassis with the cable management kit.
2 - 2 | Chapter 2: Basic installation |