Setting the Ringer Controls
Adjust the ringer on the base unit to the desired volume level (i.e.; OFF, LOW, or HIGH).
Adjust the ringer on the portable unit to the desired setting (i.e.; ON or OFF).
Even with the portable unit ringer turned to OFF, you are able to make or receive calls. However, in this mode, you will only be aware of an inbound call if you are able to hear your base unit ringer.
Setting the Tone/Pulse Switch
Adjust the tone/pulse switch on the base unit to reflect the service offered by your phone company.
If touch tone dialing is supported, set the switch to T. If using in a home office environment and rotary dialing is supported, set the switch to P.
Installing and Charging the Battery Pack
Open the battery compartment of the portable unit by grasping the portable unit (face down) with both hands, then pressing down with both thumbs to push the battery door down and away from the portable unit. Plug the battery pack lead into the portable unit connector. Place the battery pack inside the portable unit and close the battery compartment.
Place the portable unit into the cradle of the base unit and verify that the charge indicator on the base unit has turned on. Before using the
During the course of operation, recharge the battery pack as needed (see the Portable Unit Operating Procedures section regarding low battery indicators).
Bottom of portable unit
7