AT&T 4.1 Recall Timer Duration (#107)

Description
This system option lets you change the length of the timed signal, or switchhook
flash, generated by the system Recall feature (as well as by the Recall function
used in Auto Dial or System Speed Dial numbers). Recall sends this timed
signal over the phone line to the local telephone company or PBX to which the
system is connected. Typically you use the Recall feature to access a PBX,
Centrex, or local phone company custom calling feature (such as Call Waiting).
You should change the factory setting only under two conditions:
■If using the system Recall feature has no effect, lengthen the time.
If your system is connected to a PBX or Centrex system and using the
■
system Recall feature drops calls, shorten the time. (The setting typically
used for PBX systems is “18” (or 450 msec.); for Centrex systems, it is “32”
(or 800 msec.).)
Valid Entries
01 through 80 (25 to 2000 msec. in 25 msec. increments)
18 (450 msec.) ✔
Programming
To change the duration of the timed signal, follow these steps from extension 10:
1. Press [ Feature ] [ 0 ] [ 0 ].
The phone beeps once, and the light next to [ Spkr ] is green flutter.
2. Press left [
Intercom ] twice.
The light next to left [
Intercom ] is green steady.
4. Enter the setting number you want, For example, press [ 3 ] [ 2 ] to change to
800 msec.
5.
If you make a mistake, begin again at Step 3.
6.
When you are finished, press [ # ] and a three-digit code for another option or
press [ Feature ] [ 0 ] [ 0 ].
Recall Timer Duration (#107) 5-35
Recall Timer Duration (#107)
3.
Press [ # ] [ 1 ] [ 0 ] [ 7 ].