AT&T 7410 manual Select Ring and Ringer Volume, Self-Test

Select Ring (and Ringer Volume)		✔
To select a	1 While on-hook, press [ Select ]
personalized ring	● Green light goes on steadily

2Press [ Conference/Ring ]

●Green light next to [ Select ] winks; current ring pattern plays and repeats every 4 seconds

3Continue to press [ Conference/Ring ] to cycle through all

8 ring patterns

4When you hear the desired ring pattern, press [ Select ] again

●Your new ring is set; green light next to [ Select ] goes off

Note: If you receive a call, go off-hook, or lose power during selection, process is interrupted and you must start again. If you lose power after you have selected your personalized ring, you will have to select your ring pattern again.

To adjust ringer volume	1 To raise the volume, press the right half of the
if necessary	Volume control button labeled [ ▲ ] ;
	to lower the volume, press the left half of the

Volume control button labeled [ ▼ ] (There are 8 possible volume settings.)

Self-Test

To test the lights and ringer of your voice terminal

✔

1While on-hook, press [ Select ]

●Green light goes on steadily

2Press and hold [ Drop/Test ]

●Ringer sounds; all lights go on steadily

3Release [ Drop/Test ] to end test

●Ringer and lights return to pretest state; green light next to [ Select ] also goes off

Note: If ringer or lights do not respond during test, notify your System Manager.

1 7