I N S T A L L A T I O N
Standard AC Outlet | Modular Wall Jack |
|
AC Adapter
Telephone Line Cord
Power Cord
1Insert the microcassette. Lift the cover and insert the microcassette with the full reel to the right.
2Choose a spot near an electrical outlet and a telephone jack.
•This phone requires a modular telephone jack and a standard electrical outlet (120v AC).
3Install the handset battery. (For an illustration of battery installation, see “BATTERIES.”)
•Plug the battery pack connector into the handset and place the battery pack into the case, so the wires rest above the battery pack.
•Place the battery case cover on the handset by sliding it on its track up over the battery case until it snaps firmly in place.
4Set the Handset Ringer ON/OFF switch.
Set the switch on the side of the handset to ON so the handset will ring. When this switch is set to OFF the handset will not ring.
NOTE: If you set the Ringer ON/OFF switch to OFF, the handset battery will last longer. However, when the ringer is set to OFF, you will always need to press P to answer a call, even when the handset has been in the base.
5Connect the telephone line cord. Plug one end of the telephone line cord into the jack on the back of the base. (If you are wall mounting the phone, wrap the excess cord in the groove on the bottom of the base.)
Plug the other end of the line cord into a modular phone jack. Make sure the plug snaps firmly in place.
6Mount the base on the wall.
(WALL MOUNTING ONLY) Hold the base so that the mounting knobs on the standard wall jack will fit into the holes on the bottom of the base. Slide the base down onto the knobs until it locks into place.
7Connect the power cord.
Plug the power cord into the jack labeled POWER on the back of the base. Plug the AC adapter on the power cord into an electrical outlet. The microcassette will automatically rewind. When the tape stops moving, the light above the Pbutton
1
