Appendix C
Expansion handset
Adding and registering handsets (optional)
Handsets purchased separately (AT&T CL80109) need to
be registered to the telephone base before use. When first | NOT REGISTERED | |
| ||
purchased, all expansion handsets show NOT REGISTERED on |
| |
the screen. New handsets may need to be charged without |
| |
interruption for at least 30 minutes before registering to the |
| |
telephone base. |
| |
To register a handset to your telephone base |
| |
1. Make sure the handset is out of the telephone base or |
| |
charger and shows NOT REGISTERED before you begin | NOT REGISTERED | |
registration. |
| |
2. Press and hold HANDSET LOCATOR on the telephone |
| |
base for about four seconds (until the red IN USE light on |
| |
the telephone base is on) and then release the button. The | PRESS HNDST LOC | |
IN USE light remains on while the telephone base attempts | 4 SEC ON BASE | |
to register a handset. |
| |
3. Place the unregistered handset into the telephone base or |
| |
charger, PRESS HNDST LOC 4 SEC ON BASE shows on the | PLEASE WAIT... | |
handset screen. The handset is now registering with the | ||
| ||
telephone base. The handset then shows PLEASE WAIT... |
| |
and it takes up to 60 seconds to complete the registration. |
| |
There is a beep sound when the registration is successful. |
| |
The handset shows HANDSET X REGISTERED, with X being | HANDSET X | |
the handset number | ||
REGISTERED |
NOTES:
1.If the registration is not successful, the screen shows NOT REGISTERED. To reset the handset, remove the handset from the telephone base or charger, then start again from step 2 above.
2.You cannot register a handset if any other system handset is in use.
40
