AT&T E1813B, E1814B Day & time announcements, To set day and time, ’‹”ƒ’’†ƒŒƒ–’‘ƒ’’‡Œ Ɠ

1. CLOCK.

The system will announce the current clock setting, then announces “To set the clock, press CLOCK.”

2. CLOCK.

The system will announce the current day setting, then

announces “To change the day, press SKIP or REPEAT , to change the hour, press CLOCK.”

3.SKIP or

REPEAT

until the system announces the correct day, then press

CLOCK.

4.SKIP or

REPEAT

until the system announces the correct hour, then press

CLOCK.

SKIP or

5. REPEAT

until the system announc- es the correct minute, then press CLOCK.

6.SKIP or

REPEAT

until the system announc- es the correct year, then press CLOCK. The system announces the current clock setting.

Answering system operation

Day & time announcements

To set day and time

Before playing each message, the answering sys- tem announces the day and time when the mes- sage was received.

Before using the answering system, follow the steps on the left of this page to set the day, time and year, so that messages are dated correctly. If the clock is not set, before new messages are recorded, the system will announce "Time and day not set" before each message is played back.

The system uses voice prompts to guide you. Each time you press SKIP or REPEAT , the day, hour, minute or year increases or decreases by one. When you hear the correct setting, press CLOCK

’‹”ƒ’’†ƒŒƒ–’‘ƒ’’‡Œ…Ɠ

To check day and time

You can press CLOCK at any time to hear the cur- rent day and time without changing it.

NOTES:

1.You can press and hold SKIP or REPEAT to increase or decrease the minutes or years by ten.

ǎƓŠŠƒ Ž”‡‚ƒ‘’†ƒ’‡‹ƒŒ‚‚’ƒƓƒ’’†ƒ—ƒ‘’†’

’†ƒ‚—„’†ƒ•ƒƒ‰Œ€ƒŠ“Š’ƒ‚„‹’†ƒŠŠƒ 

information. After you set the time once, it will thereafter

€ƒ ‘ƒ’ “’‹’‡ŠŠ— •‡’† ‡Œ‹‡Œ… ŠŠƒ  ‡Œ„‹’‡ŒƓ

The time will be set automatically only if you subscribe to

ŠŠƒ ‘ƒ”‡ƒŽ”‡‚ƒ‚€——“ŠŠ’ƒŠƒŽ†Œƒ‹ŽŒ—

(page 27).

34