AT&T E5812B, E1814B Changing feature options, Feature options ƪƒ„“Š’‘ƒ’’‡Œ ‘“Œ‚ƒŠ‡Œƒ‚ƫ

Answering system operation

1. SETUP

until desired feature is heard (see list at right).

2. SKIP or

REPEAT

until desired selection is heard.

3. SETUP

to set selection and move’Œƒ–’‹ƒŒ“ option.

- OR -

PLAY/STOP

to set selection and exit menu.

Changing feature options

You can change how the answering system oper- ates. Press SETUP repeatedly to hear each feature. When you hear the feature you want to modify press SKIP or REPEAT to change the setting. Press PLAY/STOP ’Œ„‡‹’†ƒ‘ƒ’’‡Œ…Œ‚ƒ–‡’ the menu.

Feature options ƪƒ„“Š’‘ƒ’’‡Œ…‘“Œ‚ƒŠ‡Œƒ‚ƫ

System announces:	Feature description:
"Number of rings," cur-	Choose number of rings before
rent setting, then "To	the system answers a call. When
change the setting press	toll saver is active, the system
SKIP or REPEAT; to con-	answers after two rings if you
tinue setup, press SETUP."	have new messages, and after
Ž’‡Œ‘ƒǎƤ4/6/toll saver	four rings if you have no new
	messages. When retrieving mes-
	sages from a long distance call,
	you may disconnect your call
	after three rings so that there
	will be no long distance charge
	incurred.
“Base ringer,” current set-	Choose the base ringer volume
ting, then “To change the
	between high and low level, or
setting, press SKIP or	turn the base ringer off.
REPEAT; to continue setup,
press SETUP.”
Ž’‡Œ‘ƒ†‡ †Ƥlow/off

NOTES:

1.The message alert tone will beep only if all the conditions below are met:

Answering system is on

Message alert tone setting is on

Have new messages

ǎƓ ƒ‘‘ Œ— €‘ƒ ‰ƒ— ƪƒ–ƒŽ’

"Remote access code," current setting, then "To change the setting press SKIP or REPEAT; to con- tinue setup, press SETUP." Ž’‡Œ‘ƒ ƪ‘ƒŠƒ’  ’•ƕ digit code) 19

Select a two-digit number (10-99) for remote access from another telephone (page 41).

NOTE: Press and hold SKIP

or REPEAT to increase or decrease the remote access code number by ten.

HANDSET LOCATOR) to temporarily silence the mes- sage alert tone. If you press and hold DELETE you will delete all old messages and the message alert tone will be temporarily silenced. The message alert tone will be ƒƕ’‡”’ƒ‚ •‡’† ’†ƒ Œƒ–’ incoming message.

"Message alert tone," When on, the telephone beeps current setting, then "To every 10 seconds when there are change the setting, press new messages.

SKIP or REPEAT; to con- tinue setup, press SETUP." Ž’‡Œ‘ƒŒƤoff

36