AT&T E5860 Battery installation & charging, Did You Know? Did You Know?, Getting Started

ATT-5860CIB-d2.qxd 1/3/2004 11:09 AM Page 7

Getting Started

Battery installation & charging

After installation, place the handset in the base and allow batteries to charge for 12 hours before use. You can keep batteries charged by returning the handset to the base after each use. When battery power is fully depleted, a full recharge takes about 8 hours.

Press coin into slot on base of handset to release latch, then remove battery cover

To replace battery cover

Insert top tab first

1

LOW BATTERY

REDIAL 2:10 PM CID LOG

Low battery indicator

Return handset to base to recharge when this symbol flashes. (Handset will beep when battery is low.)

Insert supplied batteries

Caution: Use only AT&T 2AA NiCad or NiMH rechargeable batteries. Do not use AA alkaline batteries.

Place handset in base to charge for 12 hours before first use.

Rotate antenna to fully upright position

Press down to click in place

DID YOU KNOW?

DID YOU KNOW?

Optional spare batteries can be kept charged in Optional spare batteries can be kept charged in the base, for quick replacement when handset the base, for quick replacement when handset batteries become depleted (see page 42). batteries become depleted (see page47

7