50
Appendix
Troubleshooting
Incomplete
messages.
• If a caller leaves a very long message, part of it may be lost
when the system disconnects the call after four minutes.
• If the caller pauses for more than seven seconds, the system
stops recording and disconnects the call.
• If the system’s memory becomes full during a message, the sys-
tem stops recording and disconnects the call.
• If the caller's voice is very soft, the system may stop recording
and disconnects the call.
Difficulty hear-
ing messages. •.Press.VOLUME.^.to increase speaker volume.
System does
not answer
after correct
number of
rings.
• Make sure that the answering system is on (see page 30).
• If Toll Saver is activated, the number of rings changes to two
when you have new messages waiting (see page 34).
• In some cases, the system may be affected by the ringing sys-
tem used by the local telephone company.
• If the memory is full or the system is off, the system will answer
after 10 rings.
“CL” flashes
in message
window.
• You need to reset the answering system clock (see page 31).
Common cure
for electronic
equipment.
• If the phone does not seem to be responding normally, try
putting the cordless handset in its base. If it does not seem to
respond, do the following (in the order listed):
• Disconnect the power to the base.
• Disconnect the cordless handset battery, and spare battery, if
applicable.
• Wait a few minutes.
• Connect power to the base.
• Re-install the battery pack, and place the cordless handset into
the base.
• Wait for the cordless handset to re-establish its connection with
the base. To be safe, allow up to one minute for this to take
place.