AT&T HS-8500 user manual Installation, Belt Clip

I N S T A L L A T I O N

Standard electrical outlet

Modular telephone jack

Power cord

Telephone line cord

1Choose a spot near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch. For better range coverage, install the phone on the the upper-most level of your home.

2Install the handset battery.

(For an illustration of battery installation, see

BATTERIES.)

•Remove the battery cover by pressing on the indentation and sliding downward.

•Place the new battery pack in the compartment. Make sure the metal contacts on the end of the battery are aligned with the charging contacts in the battery compartment.

•Replace the battery cover by sliding it on its track up over the battery compartment until it snaps firmly into place.

3Connect the telephone line cord.

Plug one end of the telephone line cord into the jack labeled TEL LINE on the back of the base. Plug the other end of the line cord into a modular jack. Make sure the plugs snap firmly into place.

4Connect the power cord.

Plug the power adapter into the jack labeled POWER on the back of the base. Loop the cord through the strain-relief groove, and press the cord into the groove on the back of the base. Plug the AC adapter on the power cord into an electrical outlet.

NOTE: Connect power to the base unit before placing the handset in the cradle.

5Charge the handset battery for four hours.

Place the handset face up or face down in the base. The CHARGING light on the base goes on to show the handset is in the right position to charge the battery.

6Check for dial tone.

After the battery is charged, pick up the handset. Press P; you should hear a dial tone.

7Set the dial mode.

If you have touch tone service, the phone is ready to use as soon as the battery is charged.

If you have dial pulse (rotary) service, you’ll need to

change the dial mode. When the phone is off, press G(the PHONE light flashes), ###3to set

the dial mode to Dial Pulse. You’ll hear a three-beep

confirmation. To return to touch tone dialing (with touch tone service), press G, ###8.

Belt Clip

If you wish, you can attach the belt clip to the cordless handset, following the illustrations below. (The handset may not be charged in the face-up position if the belt clip is attached.)

Slide	Push
Down	Up and
into	Away
Grooves	To
To	Remove
Attach

1