AT&T PARTNER Plus Communications System Release 3 manual Connecting Intercom Autodialers

Connecting Intercom Autodialers

Since the autodialer has a fixed stand, you may need to adjust the height of the system phone—by installing a stand—to match the height of the autodialer. Refer to Step 2 of “Desk Mounting” under “Assembling System Phones” for instructions.

You can wall mount an Intercom Autodialer to work next to a wall-mounted system phone; however, wall-mounting system display phones is not recommended.

1	A)	Unplug the phone’s modular telephone cord from
		the jack on the bottom of the phone and the
		wall jack, and save the cord for Step 1D.
	B)	Plug one end of the D8W cord, supplied with the
		autodialer, into the jack on the bottom of the
		phone. (If the phone has multiple jacks, plug
		the cord into the “LINE” jack.)
	C)	Route the other end through the groove at the
		back of the autodialer and plug it into the OUT
		jack.
	D)	Route one end of the modular telephone cord
		through the groove at the back of the
		autodialer and plug it into the IN jack; plug the
		other end into the wall jack for extension 10 or
2		11.
	A)	Connect the keyed power cord, supplied with the
		autodialer, to the POWER jack on the bottom
		of the autodialer, routing it through the groove
		as you did in Step 1.
	B)	If the keyed power cord is not attached to the
		power supply unit, plug the free end of the
		cord into the modular jack on the power
		supply unit; otherwise, go to Step 2C.
	C) Plug the power unit into the electrical outlet.
		CAUTION:
		Use only the power unit supplied by AT&T
3		for the Intercom Autodialer.
	A)	Arrange the autodialer on your desk next to the
		phone.

B) Remove the plastic cover from each autodialer and label the button sheet with employee names. Place the button sheet back on the autodialer, and then carefully replace the plastic cover.

Power

Unit

In Out

Power

Wall Jack

16 Installation Procedures