AT&T PARTNER Plus Communications System Release 3 manual Required Parts

Required Parts

You will have up to three types of system component packages; Figure 1 shows the contents of each package in the area marked by a dashed line. Check your packages to be sure you have the parts shown here (if not, call the appropriate support telephone number as instructed on the inside front cover).

Control Unit

MLS-34D

Programming

Overlay

			MLS-18D/MLS-12D
			Programming
Cover			Overlay	Quick Reference
	Processor	Backplane		Cards
	Module
	AC Power Cord
			400 Module
206 Module

	7-foot
	Telephone
	Line Cords	7-foot
206	400	Telephone
		Line Cords
Module	Module

Figure 1. Required Parts

You will need to obtain four #12 screws of the appropriate type for the wall and weight of the control unit (a control unit with four 206 modules and a processor module weighs approximately 27.5 pounds or 12.3 kilograms).

In addition, if you need modular telephone cords for connecting the extension jacks on the control unit to the modular connecting blocks for extensions in the equipment room, short telephone cords for wall mounting MLS-model phones, or a 355A/355AF adapter and D8W telephone cord for connecting a call reporting device, order them before installation. Refer to “Product Ordering Information” in Appendix B of the PARTNER Plus Communications System Programming and Use guide for ordering instructions.

NOTE:

Asystem display phone—either an MLS-34D, MLS-18D, or MLS-12D—is required for system programming at extension 10 and/or 11. (Make sure that the programming phone is as large as the largest phone in the system, because an MLS-12D or MLS-18D cannot program an MLS-34D. Similarly, an MLS-12D cannot program an MLS-18D.)

4Required Parts