AT&T SB67108 user manual Notify alert

Getting started

Mailbox setup

1.When the handset is idle, press MENU/ENTER.

2.Press DIR or CID to scroll to Mailbox setup.

3.Press MENU/ENTER twice to select Set access code.

4.Use the dial pad to enter a four-digit number. Press OFF/CLEAR to backspace and delete a digit.

Set access code Notify alert

Back

Enter mailbox access code :0001

BackNext

5.Press the Next softkey or MENU/ENTER to save the password and to select Mailbox security.

6.Press DIR or CID to select On or Off.

Mailbox security :Off

7. Press MENU/ENTER to save the setting and return Back

to the previous menu. There is a confirmation tone. To exit without

making changes, press OFF/CLEAR.

NOTES:

1.The access code must have four digits.

2.You will hear an error tone and the screen displays Please enter another if you enter an access code that is already assigned.

Notify alert

You can receive notification calls to your cell phone or paging device after each new phone call message has been recorded to the handset mailbox. You can remotely access the message from a touch-tone telephone (see page 65). To receive notification calls, you must save your telephone number on the handset, and then set the system

to call that number after it finishes recording a message. It is best to enter a telephone number that has caller ID service. When you receive a notification call you will only hear silence. The silence will last for about 15 seconds and then the call ends. If no one picks up the call within three rings, the telephone base stops calling it. The system only calls the alert number once. If your paging device is busy, not available or off during the call, you will not receive the notification call.

21