HARDWARE INSTALLATION:
FOLLOW THE STEPS BELOW SET UP YOUR AT&T REMOTE MONITOR STARTER KIT:
1.Take the XG1000 Controller AC Power Supply [A1] from your controller box. Plug the small end into the port marked Power on your XG1000 Controller [X1] and plug the other end into an AC electrical outlet.
A1X1
2.Connect supplied Ethernet Cable [E1] to the LAN Ethernet port of the XG1000 Controller [X1] and connect the other end to a free Ethernet port on your router.
E1
1 2 3 4
LANWAN
X1ROUTER
3.Connect one end of Ethernet Cable [E2] to the port on the bottom of the HomePlug
Turbo PLC Ethernet Adapter [H1]. Connect the other end to a second free port on your router.
NOTE: You can connect a network hub or switch to any available Ethernet port on your router, if you need additional ports.
Plug the HomePlug Turbo PLC Ethernet Adapter [H1] into an AC electrical outlet.
For best results plug the HomePlug Turbo PLC Ethernet Adapter modules into a free AC wall outlet directly or, if not possible, into an AC power strip that has no other AC Power Supply plugged into it. The length of the power strip cord, or separate extension cord, should be no more than 5 feet and it should not be coiled.
H1 
E2
1 2 3 4
LANWAN
ROUTER
Once plugged into the AC electrical outlet, the LED’s light up on the front of the HomePlug Turbo PLC Ethernet Adapter [H1] should light up. If the LED’s do not light up on the front of the HomePlug Turbo PLC Ethernet Adapter [H1], please confirm that there is AC power coming to the outlet.
4.Bring your IP Camera [C1], AC Power Supply [A2], HomePlug Turbo PLC Ethernet Adapter [H2], and Ethernet Cable [E3] to the location in your home that you wish to install your IP Camera [C1].
Connect one end of the Ethernet Cable [E3] to the LAN port of the IP Camera [C1] and connect the other end to the port on the bottom of the HomePlug Turbo PLC Ethernet Adapter [H2]. Plug the HomePlug Turbo PLC Ethernet Adapter [H2] into an AC electrical outlet.
C1
H2
E3
Plug the small end of the AC Power Supply [A2] into your IP Camera [C1] AC Adapter port and the other end into an AC electrical outlet.
C1
A2
NOTE: If you prefer not to use the HomePlug Turbo PLC Ethernet Adapters, you may connect the IP Camera directly to your router or other Ethernet port in your home instead.
An example of the completed configuration can be found below.
|
| PLC ETHERNET |
|
|
| |
|
|
| ADAPTER |
|
|
|
|
|
| H1 | VIDEO TRANSMITTED OVER |
| |
|
|
|
|
| ||
|
|
|
| POWER LINES VIA PLC ETHERNET ADAPTERS |
| |
A1 |
|
| E2 |
|
| A2 |
|
|
|
|
|
| |
E1 |
|
|
|
|
|
|
1 | 2 | 3 | 4 |
|
| H2 |
|
|
|
|
| INTERNET | |
|
|
|
|
|
| |
|
| LAN | WAN | LAN |
| E3 |
|
|
|
|
|
| |
XG1OOO CONTROLLER |
| ROUTER | DSL/CABLE MODEM | IP CAMERA |
| |
X1 | (NOT INCLUDED) | (NOT INCLUDED) | C1 |
| ||
COMPLETED CONFIGURATION
3 | 4 |
