CN8600 User Manual

Automatic Mouse Synchronization (DynaSync)

Mouse DynaSync provides automatic locked-in synching of the remote and local mouse pointers – eliminating the need to constantly resync the two movements.

The icon on the toolbar indicates the synchronization mode status as follows:

Icon

Function

The green check mark on this icon indicates that Mouse DynaSync is available and is enabled. This is the default setting when Mouse DynaSync is available. (See the Note, above.)

The red X on this icon indicates that Mouse DynaSync is available but is not enabled.

When Mouse DynaSync is available, clicking the icon toggles its status between enabled and /disabled. If you choose to disable Mouse DynaSync mode, you must use the manual syncing procedures described in the next section.

Manual Mouse Synchronization

If you are using Manual mouse synchronization instead of automatic DynaSync and the local mouse pointer goes out of sync with the remote system's mouse pointer, there are a number of methods to bring them back into sync:

1.Perform a video and mouse auto sync by clicking the Video Settings icon on the Control Panel (see page 77).

2.Perform an Auto Sync with the Video Adjustment function (see Video Settings, page 77, for details).

3.Invoke the Adjust Mouse function with the Adjust Mouse hotkeys (see Adjust mouse, page 69, for details).

4.Move the pointer into all 4 corners of the screen (in any order).

5.Drag the Control Panel to a different position on the screen.

6.Set the mouse speed and acceleration for each problematic computer attached to the switch. See Additional Mouse Synchronization Procedures, page 146, for instructions.

88