CN8600 User Manual
Mode
Use this section to set the working mode parameters.
Enable ICMP so that the CN8600 can be pinged. If it is not enabled, the device cannot be pinged. The default is Enabled.
Enable Multiuser Operation to permit more than one user to log into the CN8600 at the same time. The default is Enabled.
Enable Virtual Media Write allows redirected virtual media devices on a user’s system to send data to a remote server, as well as being able to have data from the remote server written to them. The default is Enabled.
Browser Service allows the administrator to limit the scope of browser access to the CN8600. Put a check in the checkbox to enable this function, then select the browser limitation in the drop down list box. Choices are explained in the following table:
Item | Explanation |
|
|
Disable Browser | If this is selected, the CN8600 cannot be accessed via |
| a browser. It can only be accessed from the AP |
| programs (see AP Operation, page 91). |
|
|
Disable HTTP | If this is selected, the CN8600 can be accessed via a |
| browser, but not from an ordinary (HTTP) login |
| connection – it can only be accessed over a secure |
| HTTPS (SSL) connection. |
|
|
Disable HTTPS (SSL) | If this is selected, the CN8600 can be accessed via a |
| browser over an ordinary (HTTP) login connection, but |
| not via a secure HTTPS (SSL) connection. |
|
|
If Disable Authentication is checked, no authentication procedures are used to check users attempting to log in. Users gain Administrator access to the CN8600 switch simply by entering combination of username and password.
Note: Enabling this setting creates an extremely dangerous result as far as security goes, and should only be used under very special circumstances.
46