Introduction

CS-1754 Front View

1 & 2

3 4

1.Port Selection Switches

w Press a switch to access the computer attached to its corresponding port.

w Pressing Buttons 1 and 2 simultaneously for 2 seconds performs a keyboard and mouse reset.

w Pressing Buttons 3 and 4 simultaneously for 2 seconds starts Auto Scan Mode. See p. 21 for details.

2.Port LEDs

The Port LEDs are built into the Port Selection Switches. The upper ones are the On Line LEDs; the lower ones are the Selected Port LEDs:

w The On Line LEDs light ORANGE to indicate that the computer attached to the corresponding port is up and running. If the LED is flashing, it indicates that the Port is being used for cascading to another Master View switch (see Two Stage Installation, p. 11).

w The Selected LEDs light GREEN to indicate that the computer attached to the corresponding port is the one that has the KVM focus. The LED is steady under normal conditions, but flashes when its port is accessed under Auto Scan Mode (see p. 21 and F7 SCAN, p. 37).

3.Reset

Use a thin object (such as the end of a paper clip, or a ballpoint pen), to press this recessed switch in to initiate a warm reset. If the switch is kept in for longer than three seconds, a cold reset takes place.

4.Power LED

Lights to indicate that the unit is receiving power.

4

CS-1754 / CS-1758 User Manual