Installation

1.Make sure that the power to any device that you connect to the installation has been turned off. You must unplug the power cords of any computers that have the Keyboard Power On function.

2.Make sure that all devices you will be installing are properly grounded.

To set up your CS-82A / CS-84A installation, refer to the installation diagram on the next page (the numbers in the diagram corresponds to the steps, below), and do the following:

1.Plug your PS/2 keyboard, and PS/2 mouse into the Console ports located on the unit’s front panel.

2.Plug your monitor into the Console port located on the unit’s back panel.

3.Using the Custom KVM cable sets provided, plug the monitor, keyboard, and mouse connectors into the KVM Port sections of the CS-82A / CS-84A.

4.At the other end of the cable, plug the corresponding monitor, keyboard, and mouse connectors into their respective ports on the computers you are connecting.

Note: Verify that all plugs are in the same KVM Port sockets (all in Port 1, all in Port 2, etc.). Each socket is marked with an appropriate icon.

5.If you choose to use external power (which is optional if your installation does not exceed 10 m), plug the power adapter into an AC power source, then plug the power adapter cable into the CS-82A / CS-84A’s power jack.

6.Turn on the power to the computers.

Note: The CS-82A / CS-84A’s Power On default is to link to the first computer you turn on.

- 10 -