EC1000 User Manual
(Continued from previous page.)
3.Select the device in the Device List.
Note: 1. If the list is empty, or your device doesn't appear, click Enumerate to refresh the Device List.
2.If there is more than one device in the list, use the MAC address to pick the one you want. The eco PDU's MAC address is located on its bottom panel.
4.Select either Obtain an IP address automatically (DHCP), or Specify an IP address. If you chose the latter, fill the IP Address, Subnet Mask, and Gateway fields with the information appropriate to your network.
5.Click Set IP.
6.After the IP address shows up in the Device List, click Exit to end the program.
Method 2:
1.Set your computer's IP address to 192.168.0.XXX
Where XXX represents any number or numbers except 60. (192.168.0.60) is the default address of the Energy Box.)
2.Specify the device’s default IP address (192.168.0.60) in your browser, and you will be able to connect.
3.Assign a fixed IP address for the device (see IPv4 Configuration, page 37), that is suitable for the network segment that it resides on.
4.After you log out, reset your computer's IP address to its original value.
5.Once you have logged in, go to Network Settings to set up the permanent IP environment (see IPv4 Configuration, page 37).
Method 3:
NRGence™ eco Sensors allows you to determine/assign an IP address in order to configure a Energy Box and monitor power status of the equipment connected to it. NRGence™ eco Sensors can be obtained from the Download area of the ATEN web site.
98