ATEN Technology VS0102, VS0104, VS0108 Hardware Setup, Rack Mounting, Phillips hex head

1 33

Chapter 2

1.Important safety information regarding the placement of this device is provided on page 20. Please review it before proceeding.

2.Make sure that the power to all devices connected to the installation are turned off.

3.Make sure that all devices you will be installing are properly grounded.

For convenience and flexibility, the VS0102 / VS0104 / VS0108 can be mounted on system racks. To rack mount a unit do the following:

1.Using the screws provided in the Rack Mount Kit, screw the mounting bracket into the side of the unit as show in the diagram below:

M3x6

Contents

VS0102 / VS0104 / VS0108 FCC Information RoHS SJ/T User Information Online Registration Telephone Support User Notice Package Contents Contents 1. Introduction 2. Hardware Setup 3. Operation Appendix About this Manual Conventions Product Information Introduction Overview Features Requirements Source Device Display Device Cables Operating Systems Components VS0102 / VS0104 / VS0108 Front View VS0102 Rear View VS0104 Rear View VS0108 Rear View Hardware Setup Rack Mounting Phillips hex head Grounding Installation Single Stage Installing the RS-232Controller Cascade Operation RS-232Serial Interface Configuring the Serial Port Switch Port Commands Command for Cascaded Splitters EDID Mode Selection Commands Mute Commands Firmware Update Command Read Command Reset Device Command Verification Powering Off and Restarting Appendix Safety Instructions General Page Rack Mounting Technical Support International North America Specifications Limited Warranty