ATEN Technology VS0102, VS0104, VS0108 Grounding, Note:

Chapter 2. Hardware Setup

2. Screw the bracket into any convenient location on the rack.

Note: These screws are not provided. We recommend that you use M5 x 12 Phillips Type I cross, recessed type screws.

Grounding

To prevent damage to your installation it is important that all devices are properly grounded.

1.Use a grounding wire to ground the VS0102 / VS0104 / VS0108 by connecting one end of the wire to the grounding terminal, and the other end of the wire to a suitable grounded object.

2.Make sure that the computer(s)/device(s) that the VS0102 / VS0104 / VS0108 connects to are properly grounded.

Contents

VS0102 / VS0104 / VS0108 FCC Information RoHS SJ/T User Information Online Registration Telephone Support User Notice Package Contents Contents 1. Introduction 2. Hardware Setup 3. Operation Appendix About this Manual Conventions Product Information Introduction Overview Features Requirements Source Device Display Device Cables Operating Systems Components VS0102 / VS0104 / VS0108 Front View VS0102 Rear View VS0104 Rear View VS0108 Rear View Hardware Setup Rack Mounting Phillips hex head Grounding Installation Single Stage Installing the RS-232Controller Cascade Operation RS-232Serial Interface Configuring the Serial Port Switch Port Commands Command for Cascaded Splitters EDID Mode Selection Commands Mute Commands Firmware Update Command Read Command Reset Device Command Verification Powering Off and Restarting Appendix Safety Instructions General Page Rack Mounting Technical Support International North America Specifications Limited Warranty