ATEN Technology VS0102, VS0104, VS0108 Firmware Update Command, upgrade [Enter]

1 33

VS0102 / VS0104 / VS0108 User Manual

The Firmware Update feature readies the VS0102 / VS0104 / VS0108 for a firmware upgrade.

The formula for the Firmware Update command is as follows: Command [Enter]

For example, to start the firmware upgrade process, input the following:

The following tables show the possible values and formats for the command:

Command	Description

upgrade	Starts the upgrade process for
	the device

The following table shows the available command list:

Contents

VS0102 / VS0104 / VS0108 FCC Information RoHS SJ/T User Information Online Registration Telephone Support User Notice Package Contents Contents 1. Introduction 2. Hardware Setup 3. Operation Appendix About this Manual Conventions Product Information Introduction Overview Features Requirements Source Device Display Device Cables Operating Systems Components VS0102 / VS0104 / VS0108 Front View VS0102 Rear View VS0104 Rear View VS0108 Rear View Hardware Setup Rack Mounting Phillips hex head Grounding Installation Single Stage Installing the RS-232Controller Cascade Operation RS-232Serial Interface Configuring the Serial Port Switch Port Commands Command for Cascaded Splitters EDID Mode Selection Commands Mute Commands Firmware Update Command Read Command Reset Device Command Verification Powering Off and Restarting Appendix Safety Instructions General Page Rack Mounting Technical Support International North America Specifications Limited Warranty