Clipper USB
1.15 Uninstalling the Clipper USB
Windows
The setup information for the Clipper is saved by Windows. If you decide to permanently remove the driver and utility of the Clipper from your system, you must run the uninstallation program from the ISDN Utility program group as follows:
•Open the Programs folder on the Start menu and click the Clipper ADSL USB Modem item.
•Click the Uninstall item. The uninstallation program will run.
•A message will be displayed asking you to remove of the ADSL USB Modem software, click Yes.
The USB cable should not be unplugged until you are prompted to do so.
The USB cable must be unplugged before the system is rebooted.
Linux
To unload an unused module:
%rmmod ./GSPNModem (Command to be executed from directory monaco_linux/ModemDrv)
You may need to exit or disconnect any program current using the module before it will unload. If the module was configured for LAN, shutdown the ethernet interface:
%ifconfig eth2 down
Note: If multiple ethernet interfaces are created then all the ethernet interfaces need to be brought down before